![]() These early Maxon made pickups have a tendency to break where the lead wires attach to the coil so all wasn't lost just yet. I thought I was going to have to fire up the winder? The neck was reading a healthy 8.5K so I unsoldered the wires from the pot and measured again. No resistance at all from the bridge pickup. I took the back plate off to check the wiring and measure the pickups. ![]() In this case, this still didn't get any noise from that pickup. ![]() I usually start by cleaning out all the pots, the switch and the jack as time can corrode these and make bad contact for the signal to pas through. The guitar itself is in pretty good condition but when I plugged it in, no sound from the bridge pickup? I was getting some guitars ready to take to the shop and pulled out this '73 Greco LP for a quick clean and set up.
0 Comments
Leave a Reply. |